Free Calculator · Published October 2026
Liters to Quarts Converter: Multiply by 1.0568
Put a liter volume and a quart volume on the same line before anyone treats them as two jugs.
Built by SubcontractorHub — the software plumbing contractors use to quote, finance, and run every job.
Book a DemoHow the Liters to Quarts Converter Uses 1.0568
This page follows one line on the USGS facts about water page: 1 liter = 1.0568 quart. Gallons and liters, with no quarts, stay on the gallons to liters converter. Multiply liters by 1.0568. The reverse divides quarts by 1.0568.
Liters, or quarts. Not a gallon and not a flow.
All calculations are estimates based on historical information and should be verified by the user.
Important: All calculator results are ballpark estimates
All calculations are estimates based on historical information and should be verified by the user. This tool is provided as a free service for planning purposes only and is not a substitute for a professional assessment, a supplier quote, or applicable local code requirements.
What Is the Liters to Quarts Converter Using?
The printed liter is 1.0568 quarts. The result is a unit change. It does not say how much bleach to pour, how large a tank is, or whether a sample passed a county rule. Write both units on the ticket so the next visit does not treat them as two volumes.
One factor, both directions
The water-facts page prints 1 liter = 0.2642 gallons = 1.0568 quart. It also prints 1 gallon = 4 quarts = 3.7854 liters. This page uses 1.0568 so a liter round-trips through quarts. It does not build quarts by multiplying 3.7854 and then dividing by 4.
One quart divided by 1.0568 is about 0.94625. Rounded to four decimals, that display reads 0.9463. The engine divided by 1.0568. It did not multiply by 0.2642, and it did not divide a gallon into four.
Worked examples
Each row uses 1.0568. One liter is 1.0568 quarts. Ten liters are 10.568 quarts. The reverse of 1.0568 quarts is 1 liter. One quart is 0.9463 liters at four decimals.
| Case | Quarts | Liters |
|---|---|---|
| 1 liter | 1.0568 | 1 |
| 10 liters | 10.568 | 10 |
| 1.0568 quarts | 1.0568 | 1 |
| 1 quart | 1 | 0.9463 |
A quart is not a minute rate
Liters per minute stay on the liters per minute to GPM converter. Gallons with no quarts stay on the gallons to liters converter. This page has no 3.7854 and no minutes.
What to write on the job ticket
Write five lines before the number leaves this page. A later visit should not have to guess which factor was used.
- The entered value, and whether it was liters or quarts.
- The factor, 1.0568, named as the USGS liter line.
- Both results, quarts and liters.
- Which jug, label, or sheet the volume came from.
- A note that 3.7854, 0.2642, and 4 quarts per gallon were not applied.
What stays off this unit change
A bleach jug marked in quarts is still not a dose. This page does not ask for a percent or a target. A shock procedure that talks about quarts of bleach is a different article, and this converter does not replace it.
A water treatment dealer who saves the 1.0568 note will not swap in 3.7854 and call the result quarts. This conversion does not size a softener and does not say a sample passed a county rule. A private-well lab sheet is still the well water testing guide.
Frequently Asked Questions
What does this quart converter change?
It converts liters and quarts using 1.0568, the figure USGS prints for one liter in quarts. The tool multiplies and divides by that figure. It does not use 3.7854 liters per gallon.
Why not multiply by 4 quarts per gallon?
The gallon line on the same USGS page prints 4 quarts and 3.7854 liters. This page does not multiply those two figures together. It uses the separate sentence that says 1 liter equals 1.0568 quart.
Is this the gallons to liters converter?
No. Gallons to liters uses 3.7854 and does not output quarts. This page is liters and quarts. A gallon measured with 3.7854 stays on that other tool.
Does a quart set a chemical dose?
No. The result is a unit change. It does not apply a bleach strength, a target parts per million, or a well volume.
Is 0.2642 used as the factor?
No. The same USGS sentence prints 1 liter as 0.2642 gallons and as 1.0568 quart. This page uses 1.0568 only. Gallons are not an output.
Save 1.0568 Next to the Volume
The liters, the quarts, and the USGS liter line belong on the customer record.
Get a Free DemoAll calculations are estimates based on historical information and should be verified by the user. This tool is provided as a free service for planning purposes only and is not a substitute for a professional assessment, a supplier quote, or applicable local code requirements. It does not dose a chemical.